Spring & cable repair · Cookeville, TN
Garage door spring repair in Cookeville
A loud bang from the garage, and now the door weighs three hundred pounds. That's a broken spring - the most common repair we do, and one of the fastest. Most spring jobs are done in a single visit.
How to tell it's the spring, not the opener
When a spring breaks, the opener takes the blame - it strains, lifts the door a few inches, and gives up. But the opener was never doing the lifting. The springs carry the door's weight; the opener just guides it. Three signs point at the spring:
- You heard one loud bang from the garage - often at night or on a cold morning
- The door lifts a few inches then stops, or the opener runs but the door won't budge
- There's a visible gap in the coil of the spring above the door
If that matches, stop running the opener - it can bend the top panel or snap the cables next. Pull the red release cord only if you must, and don't try to lift the door alone: without a working spring it's dead weight.
What the repair involves
We match the replacement spring to your door's exact weight and track setup - torsion (the shaft-mounted coil above the door, on most homes built since the 90s) or extension (the stretched springs along the tracks on older Cookeville houses). The job includes unloading the old spring safely, fitting and winding the new one to the door's balance point, checking cables and bottom brackets while the tension is off, and cycling the door until it sits level and lifts with two fingers.
We stock high-cycle springs too - worth the modest upcharge if your door is the main way into the house, which around here it usually is.
Cables, rollers, and the parts that fail with the spring
Cables fray at the bottom bracket, rollers wear flat, and both get checked on every spring call while the door is already safe to work on. If a worn opener has been fighting an unbalanced door for months, we'll tell you that too - with a price for each fix separately, so nothing is bundled past you.
Spring went bang this morning? Spring jobs get same-day priority.
Free written quote
Broken spring? Get the number before the visit.
Tell us roughly what happened and whether it's a single or double door - that's usually enough to name the range on the spot. Prefer to talk it through? (931) 400-8846.
- The price is in writing before a wrench comes out - parts, labor, and haul-away, no surprise line items
- Describe the symptom over the phone and we can usually name the likely part and its normal range on the spot
- One local operation for Cookeville, Algood, and Baxter - your number never gets resold to three contractors
Spring repair questions
How much does it cost to replace garage door springs in Cookeville?
A torsion spring pair typically runs $220-$420 installed around Cookeville, extension springs a bit less. Single-spring doors sit at the low end; oversized doors and high-cycle springs at the top. The exact number goes in writing before we start - see the full pricing guide.
Can I replace a garage door spring myself?
We would honestly rather you did not. A wound torsion spring stores enough energy to break a hand, and it releases all of it the instant a winding bar slips. This is the one garage door job that reliably hurts people - we wrote up why pros treat springs differently if you want the unvarnished detail.
Why did my spring break with a loud bang?
Springs are rated in open-close cycles - most builder-grade springs are 10,000 cycles, which works out to 7-10 years of normal use. Steel also fatigues faster with temperature swings, and Upper Cumberland winters deliver exactly the cold snaps that finish off a spring near its limit. The bang is the coil letting go all at once.
Should I replace both springs if only one broke?
On a two-spring door, yes, and it is not upselling: both springs have the same cycle count on them. Replace one and the survivor usually follows within months, which means paying the service-call portion twice. We price the pair so the second spring costs far less than a second visit would.